1. Main technical performance:

power supply: AC200V±10%                   Clamping diameter Φ1.5-Φ10

Stirring power: 200 W                       Collet to column center tube: 160-270 ( mm）    

Stirring speed: 60-1500 r/min               Maximum distance of chuck: 560 ( mm）

2. How to use:

1、  Installation: Install the post into the base and tighten it, tighten the set screw, install the cross on the post, and insert the main rod into the cross byte to fix it；

2、  Install the stirring rod before use. The stirring rod can be directly installed into the chuck and clamped, but the straightness of the stirring rod must be ensured.；

3、  Before turning on, first place the power switch at the off position, adjust the knob counterclockwise to the minimum, then plug in the power supply, turn on the power switch, the built-in indicator light on the switch, and slowly adjust the knob clockwise to the required speed.

3. Notes:

1、  When using the agitator, it should accelerate from slow to fast. If the straightness of the stirring rod is poor, the rotation speed cannot be fast or the soft connection shaft is used and fixed with a support sleeve in the middle.

2、  Please do not get too close to the mixer when working, so as not to cause any dangers such as clothing and hair being caught in.；

3、  Prevent liquid from splashing while stirring.